Nokia 7705 SAR - Page 519

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 519
mddb
Syntax mddb
Context config>scada
Description This command enables the context to configure MDDB parameters for a SCADA bridge.
pcm
Syntax pcm
Context config>scada
Description This command enables the context to configure PCM multidrop bridge parameters for a
SCADA bridge.
force-active
Syntax force-active master branch-id
Context config>scada>mddb
config>scada>pcm
Description This command forces a master branch to become active. The command applies only if
redundant-mode is set to manual mode.
Default 1
Parameters branch-id — the master branch that is forced to become active
Values 1 or 2
redundant-mode
Syntax redundant-mode redundant-mode
Context config>scada>mddb
config>scada>pcm
Description This command configures the redundancy mode for the master inputs of the SCADA bridge.
In manual mode, the branch must be made active manually using the force-active command
in order to receive data from the master input. The bridge always broadcasts to both master
branches.