Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 505
lacp-xmit-interval
Syntax lacp-xmit-interval {slow | fast}
no lacp-xmit-interval
Context config>lag
Description This command specifies the interval signaled to the peer and tells the peer at which rate it
should transmit.
The no form of this command returns the value to the default.
Default fast
Parameters slow — transmits packets every 30 seconds
fast — transmits packets every second
lacp-xmit-stdby
Syntax [no] lacp-xmit-stdby
Context config>lag
Description This command enables LACP message transmission on the standby link.
The no form of this command disables LACP message transmission on the standby link.
Disable LACP message transmission on the standby link if the peer does not properly follow
the IEEE 802.3ax standard regarding the LACP sync bit.
Default lacp-xmit-stdby
mac
Syntax mac ieee-address
no mac
Context config>lag
Description This command assigns a specific MAC address to the LAG.
The no form of this command returns the MAC address to the default value.
Default a default MAC address is assigned by the system
Parameters ieee-address — specifies the 48-bit MAC address in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed
values are any non-broadcast, non-multicast MAC, and non-IEEE reserved MAC
addresses.
To Next Page
Loading...
