Nokia 7705 SAR - Page 483

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 483
drop-count — the number of consecutive keepalive failed request attempts or remote
replies that can be missed after which the port is operationally downed
Values 1 to 255
scramble
Syntax [no] scramble
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command enables payload scrambling on channel groups. The command is applicable
only if the encapsulation type is atm.
timeslots
Syntax timeslots timeslots
no timeslots
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command defines the list of DS0 timeslots to be used in the DS1 or E1 channel group.
The timeslots do not need to be consecutive. If the encapsulation type is changed to or from
atm, the timeslots are reset to the default. If the encapsulation type is set to atm, the timeslot
ranges are automatically configured and cannot be changed.
If the port is configured for fractional T1/E1 (see Configuring Fractional T1/E1 Ports for PPP
Encapsulation), this command is used to specify the number of timeslots to be used on the
port. Only the specified timeslots can be used.
The no form of this command removes DS0 timeslots from a channel group.
Default no timeslots — non-ATM channel groups
1 to 24 — channel groups configured under DS1 with atm encapsulation
2 to 16, 18 to 32 — channel groups configured under E1 with atm encapsulation
2 to 32 — channel groups configured under E1 (ppp-auto)
Parameters timeslots — specifies the timeslots to be associated with the channel group. The value
can consist of a list of timeslots. Each member of the list can either be a single
timeslot or a range of timeslots.
Values 1 to 24 for DS1 interfaces. The full range is automatically configured
for ATM channel groups and cannot be changed.
2 to 32 for E1 interfaces. The 2 to 16 and 18 to 32 ranges are
automatically configured for ATM channel groups and cannot be
changed.