Nokia 7705 SAR - Page 458

7705 SAR Interfaces
458
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
mapping
Syntax mapping direct
no mapping
Context config>port>tdm>ds3>atm
Description This command specifies the ATM cell mapping to be used on this DS3 ATM interface.
The no form of this command restores the default value.
Default direct
Parameters direct — specifies direct cell mapping
min-vp-vpi
Syntax min-vp-vpi value
no min-vp-vpi
Context config>port>multilink-bundle>ima>atm
config>port>tdm>ds1>channel-group>atm
config>port>tdm>e1>channel-group>atm
config>port>tdm>ds3>atm
config>port>tdm>e3>atm
config>port>sonet-sdh>path>atm
Description This command sets the minimum allowable virtual path identifier (VPI) value that can be used
on the ATM interface for a virtual path connection (VPC).
The no form of this command restores the default value.
Default 0
Parameters value — the minimum allowable VPI value that can be used on the ATM interface for a
VPC
Values 0 to 4095 (NNI) (not supported on SDH/SONET ports)
0 to 255 (UNI)
Note: For an E3 interface, the mapping command does not appear in the CLI; the interface
is hard-coded for direct mapping.