7705 SAR Interfaces
472
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Default no remote-loop-respond
report-alarm
Syntax [no] report-alarm {ais | los | oof | rai | looped | ber-sd | ber-sf}
Context config>port>tdm>ds1
config>port>tdm>e1
Description This command enables logging of DS1 or E1 alarms. When configured, logging is enabled
for the raising and clearing of the specified alarms.
The no form of this command disables logging of the specified alarms.
Parameters ais — reports alarm indication signal errors
Default ais alarms are issued
los — reports loss of signal errors
Default los alarms are issued
oof — reports out-of-frame errors
Default oof alarms are not issued
rai — reports remote alarm indication signal errors
Default rai alarms are not issued
looped — reports looped packets errors
Default looped alarms are not issued
ber-sd — reports BER line signal degradation errors on:
• the 16-port T1/E1 ASAP Adapter card
• the 32-port T1/E1 ASAP Adapter card
• T1/E1 ports on the 7705 SAR-M
• T1/E1 ports on the 7705 SAR-X
• T1/E1 ports on the 7705 SAR-A
• T1/E1 ports on the 4-port T1/E1 and RS-232 Combination module
Default line signal degradation alarms are not issued
ber-sf — reports BER line signal failure errors on:
• the 16-port T1/E1 ASAP Adapter card
• the 32-port T1/E1 ASAP Adapter card
Note: The 4-port OC3/STM1 / 1-port OC12/STM4 Adapter card cannot respond to fdl-ansi,
fdl-bellcore, or payload-ansi loopbacks.
To Next Page
Loading...
