Nokia 7705 SAR - Page 233

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 233
hold-time {[up hold-time-up] [down
hold-time-down]}
no hold-time
loopback {line | internal}
no loopback
[no] path [sonet-sdh-index]
atm
cell-format cell-format
min-vp-vpi value
crc {16 | 32}
description description
no description
encap-type {atm | ppp-auto}
mode {access | network}
mtu mtu
no mtu
network
accounting-policy policy-id
[no] collect-stats
queue-policy name
no queue-policy
payload
ppp
keepalive time-interval [dropcount
drop-count]
no keepalive
[no] report-alarm [pais] [plop] [prdi]
[pplm] [prei] [puneq]
[no] scramble
[no] shutdown
signal-label value
no signal-label
trace-string [trace-string]
no trace-string
[no] report-alarm [loc] [lais]
[lrdi][lb2er-sd] [lb2er-sf] [slof][slos]
[lrei]
section-trace {increment-z0 | byte value |
string string}
speed {oc3}
no speed
threshold {ber-sd | ber-sf} rate threshold
[no] no tx-dus
Use the following CLI syntax to configure SONET/SDH port parameters on a 2-port
OC3/STM1 Channelized Adapter card.
CLI Syntax: port port-id
sonet-sdh