Nokia 7705 SAR - Page 366

7705 SAR Interfaces
366
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Parameters keygroup-id — the ID number of the key group being configured
Values 1 to 127 | keygroup-name (64 characters maximum)
inbound — binds the key group in the inbound direction
outbound — binds the key group in the outbound direction
hold-time
Syntax hold-time {[up hold-time-up] [down hold-time-down]}
no hold-time
Context config>port>ethernet
config>port>dsl
Description This command configures port link dampening timers, which reduce the number of link
transitions reported to upper layer protocols.
The hold-time value is used to dampen interface transitions.
When an interface transitions from an up state to a down state, interface down transitions are
not advertised to upper layers until the hold-time-down interval has expired. Likewise, when
an interface transitions from a down state to an up state, interface up transitions are not
advertised until the hold-time-up interval has expired.
If the hold-time-down or hold-time-up value is 0, interface down and interface up transitions
are immediately reported to upper layer protocols.
The no form of this command reverts to the default values.
Default down 0 or up 0 — no port link dampening is enabled; link transitions are immediately reported
to upper layer protocols
Parameters hold-time-up — the interval, in seconds, before an interface transition from a down state
to an up state is reported to upper layer protocols
Values 0 to 900
hold-time-down — the interval, in seconds, before an interface transition from an up state
to a down state is reported to upper layer protocols
Values 0 to 900
ingress-rate
Syntax ingress-rate ingress-rate cbs {size [bytes | kilobytes] | default}
no ingress-rate
Context config>port>ethernet