7705 SAR Interfaces
362
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
mode
Syntax mode {active | passive}
Context config>port>ethernet>efm-oam
config>port>dsl>efm-oam
Description This command configures the mode of OAM operation for this Ethernet port.
Active mode causes the port to initiate the negotiation process and continually send out efm-
oam information PDUs. Passive mode waits for the peer to initiate the negotiation process.
A passive mode port cannot initiate monitoring activities (such as loopback) with the peer.
Default active
transmit-interval
Syntax [no] transmit-interval interval [multiplier multiplier]
Context config>port>ethernet>efm-oam
config>port>dsl>efm-oam
Description This command configures the transmit interval of OAMPDUs.
Parameters interval — specifies the transmit interval
Values 1 to 600 (in 100 ms)
multiplier — specifies the multiplier for the transmit-interval to set the local link down
timer
Values 2 to 5
tunneling
Syntax [no] tunneling
Context config>port>ethernet>efm-oam
config>port>dsl>efm-oam
Description This command enables EFM OAMPDU tunneling. OAMPDU tunneling is required when a
loopback is initiated from a router end and must be transported over the existing network
infrastructure to the other end. Enabling tunneling will allow the PDUs to be mapped to Epipes
so that the OAM frames can be tunneled over MPLS to the far end.
To enable Ethernet EFM OAM 802.3ah on the port, use the efm-oam>no shutdown
command.
The no form of the command disables tunneling.
To Next Page
Loading...
