Nokia 7705 SAR - Page 378

7705 SAR Interfaces
378
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
100 — sets the Ethernet port speed to 100 Mb/s
1000 — sets the Ethernet port speed to 1000 Mb/s (only supported on GigE SFPs)
2500 — sets the v-port speed to 2500 Mb/s (only supported on a v-port)
10000 — sets the ring Ethernet port speed (only supported on GigE XFPs) and the SFP+
ports speed on the 6-port Ethernet 10Gbps Adapter card and a 7705 SAR-X to 10
000 Mb/s
ssm
Syntax ssm
Context config>port>ethernet
config>port>dsl
Description This command enables the Ethernet Synchronization Message Channel (ESMC) capability
on a synchronous Ethernet port on the following:
• 2-port 10GigE (Ethernet) Adapter card
• 2-port 10GigE (Ethernet) module
• 6-port Ethernet 10Gbps Adapter card
• 8-port Ethernet Adapter card, version 2
• 8-port Gigabit Ethernet Adapter card
• 10-port 1GigE/1-port 10GigE X-Adapter card
• Packet Microwave Adapter card
• 4-port SAR-H Fast Ethernet module
• DSL module port on the 7705 SAR-M (variants with a module slot)
• 7705 SAR-A
• 7705 SAR-Ax
• 7705 SAR-H
• 7705 SAR-Hc
• 7705 SAR-M (all variants)
• 7705 SAR-W
• 7705 SAR-Wx (all variants)
• 7705 SAR-X
The ssm command is enabled and disabled using the no shutdown and shutdown
commands.