Nokia 7705 SAR - Page 377

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 377
Default 0x8100
Parameters 0x0600 to 0xffff — specifies the Ethertype to expect
report-alarm
Syntax [no] report-alarm [signal-fail] [remote] [local] [no-frame-lock] [high-ber]
Context config>port>ethernet
Description This command specifies when and if to generate alarms and alarm clear notifications for this
port.
The command applies only to the physical 10GigE ports on the 7705 SAR-X, 6-port Ethernet
10Gbps Adapter card, 2-port 10GigE (Ethernet) Adapter card, and 2-port 10GigE (Ethernet)
module, and on the 10-port 1GigE/1-port 10GigE X-Adapter card in 1-port 10GigE mode
(select x1-10GigE-sf+ with the mda-mode command).
Parameters signal-fail — reports an Ethernet signal lost alarm
remote — reports remote faults
local — reports local faults
no-frame-lock — reports a “not locked on the ethernet framing sequence” alarm
high-ber — reports a high bit error rate alarm
speed
Syntax speed {10 | 100 | 1000 | 2500 | 10000}
Context config>port>ethernet
Description This command configures the port speed of an Ethernet port, ring Ethernet port, or v-port
when autonegotiation is disabled.
Default 100 (for Fast Ethernet ports on the 8-port Ethernet Adapter card, 7705 SAR-A (ports 9 to 12),
7705 SAR-Hc (ports 3 and 4), 4-port SAR-H Fast Ethernet module, and 6-port SAR-M
Ethernet module (ports 1 and 2))
1000 (for Gigabit Ethernet ports on all adapter cards, modules, and fixed platforms)
2500 on a v-port (this default cannot be changed)
10000 (for the 10-port 1GigE/1-port 10GigE X-Adapter card in 1-port 10GigE mode, 2-port
10GigE (Ethernet) Adapter card, 2-port 10GigE (Ethernet) module, 6-port Ethernet 10Gbps
Adapter card (ports 5 and 6), 7705 SAR-X (ports 1/2/7 and 1/3/7)
Parameters 10 — sets the link speed to 10 Mb/s