Nokia 7705 SAR - Page 380

7705 SAR Interfaces
380
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
tx-dus
Syntax [no] tx-dus
Context config>port>ssm
config>port>ethernet>ssm
Description This command sets the quality level value transmitted from the Synchronization Status
Messaging (SSM) channel of the following ports to QL-DUS/QL-DNU (do not use for
synchronization for timing purposes):
• synchronous Ethernet port on the 2-port 10GigE (Ethernet) Adapter card
• synchronous Ethernet port on the 2-port 10GigE (Ethernet) module
• synchronous Ethernet port on the 6-port Ethernet 10Gbps Adapter card
• synchronous Ethernet port on the 8-port Ethernet Adapter card, version 2
• synchronous Ethernet port on the 8-port Gigabit Ethernet Adapter card
• synchronous Ethernet port on the 10-port 1GigE/1-port 10GigE X-Adapter card
• synchronous Ethernet port on the Packet Microwave Adapter card
• synchronous Ethernet port on the 4-port SAR-H Fast Ethernet module
• synchronous Ethernet port on the 7705 SAR-A
• synchronous Ethernet port on the 7705 SAR-Ax
• synchronous Ethernet port on the 7705 SAR-H
• synchronous Ethernet port on the 7705 SAR-Hc
• synchronous Ethernet port on the 7705 SAR-M (all variants)
• synchronous Ethernet port on the 7705 SAR-W
• synchronous Ethernet port on the 7705 SAR-Wx (all variants)
• synchronous Ethernet port on the 7705 SAR-X
Default The value depends on whether the port type is copper or fiber. The default value is:
• enabled for fiber ports
• disabled (no tx-dus) for copper ports