Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 381
vlan-filter
Syntax [no] vlan-filter filter-id
Context config>port>ethernet
Description This command associates a VLAN filter policy with an ingress ring port on the 2-port 10GigE
(Ethernet) Adapter card or 2-port 10GigE (Ethernet) module.
Filter policies control the forwarding and dropping of packets based on matching criteria. Only
one filter policy can be applied to a ring port at a time. The same filter policy can be applied
to both ring ports.
The filter-id must already be defined before the vlan-filter command is executed. If the filter
policy does not exist, the operation will fail and an error message will be displayed.
The no form of the command removes any configured filter-id association with the ring port.
The filter policy cannot be deleted until it is removed from all ring ports where it is applied.
Default n/a
Parameters filter-id — the VLAN filter policy ID number or filter name
Values 1 to 65535 or filter-name (up to 64 characters)
xgig
Syntax xgig {lan | wan}
Context config>port>ethernet
Description This command configures the specified 10-Gb/s interface in LAN or WAN mode. When
configuring the port for WAN mode, you can change some SONET/SDH parameters to reflect
the SONET/SDH requirements for this port. When you configure a port for LAN mode, all
SONET/SDH parameters are predetermined and not configurable. The command is
supported on the 7705 SAR-X, 6-port Ethernet 10Gbps Adapter card, 10-port 1GigE/1-port
10GigE X-Adapter card, 2-port 10GigE (Ethernet) Adapter card, and 2-port 10GigE
(Ethernet) module.
On the 6-port Ethernet 10Gbps Adapter card, both 10-Gb/s interfaces (ports 5 and 6) operate
in the same xgig mode, either LAN mode or WAN mode. Setting the xgig mode for either
port sets the mode for both ports.
Default lan
Parameters lan — specifies that the port operates in LAN mode
wan — specifies that the port operates in WAN mode
To Next Page
Loading...
