Nokia 7705 SAR - Page 243

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 243
Use the following CLI syntax to configure an analog voice port on a 6-port FXS
Adapter card.
CLI Syntax: port port-id
voice
fxs
channel-group channel-group-id
description description-string
encap-type cem
mode access
no shutdown
fault-signaling {idle | seized}
loopback internal-digital
no shutdown
line-balance {nominal | 800}
ring-generation {16 | 20 | 25}
signaling-type {3600plar | 1511plar |3600ls
|1511profile1 | 3600re}
tlp-rx {-7.0 | -6.9 | ... | -0.1 | 0.0}
tlp-tx {-4.0 | -3.9 | ... | 2.9 | 3.0}
The following CLI syntax shows an example of configuring an analog voice port on a
6-port FXS Adapter card.
Example: config# port 1/6/1
config>port# voice
config>port>voice# fxs
config>port>voice>fxs# channel-group 1
config>port>voice>fxs>channel-group# mode access
config>port>voice>fxs>channel-group# encap-type cem
config>port>voice>fxs>channel-group# no shutdown
config>port>voice>fxs>channel-group# exit
config>port>voice>fxs# no shutdown
config>port>voice>fxs# exit
config>port>voice# line-balance nominal
config>port>voice# ring-generation 16
config>port>voice# signaling-type 3600ls
config>port>voice# tlp-rx -7.0
config>port>voice# tlp-tx -4.0
config>port>voice# exit
config>port# exit
config#