Nokia 7705 SAR - Page 242

7705 SAR Interfaces
242
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
config>port>voice# exit
config>port# no shutdown
config>port# exit
config#
Use the following CLI syntax to configure an analog voice port on an 8-port FXO
Adapter card.
CLI Syntax: port port-id
voice
fxo
channel-group channel-group-id
description description-string
encap-type cem
mode access
no shutdown
fault-signaling {idle | seized}
loopback internal-digital
no shutdown
line-balance {nominal | 800}
signaling-type {3600ls | 1511profile1 | 3600re}
tlp-rx decibels {-7.0 | -6.9 | ... | -0.1 | 0.0}
tlp-tx decibels {-4.0 | -3.9 | ... | 2.9 | 3.0}
The following CLI syntax shows an example of configuring an analog voice port on
an 8-port FXO Adapter card. The default values are used for the commands that are
not shown in the example.
Example: config# port 1/1/6
config>port# voice
config>port>voice# fxo
config>port>voice>fxo# channel-group 1
config>port>voice>fxo>channel-group# mode access
config>port>voice>fxo>channel-group# encap-type cem
config>port>voice>fxo>channel-group# no shutdown
config>port>voice>fxo>channel-group# exit
config>port>voice>fxo# no shutdown
config>port>voice>fxo# exit
config>port>voice# exit
config>port# no shutdown
config>port# exit
config#