7705 SAR Interfaces
440
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Parameters value — specifies the C2 byte value, expressed as a decimal integer or a hexadecimal
value
Values 1 to 254 or 0x01 to 0xfe
trace-string
Syntax trace-string [trace-string]
no trace-string
Context config>port>sonet-sdh>path
Description This command specifies that a J1-path-trace that identifies the circuit be continuously
inserted at source. The specified trace string can be checked against the expected value by
the receiver. If no trace string is entered, a null string is used.
The no form of this command resets the string to its default.
Default The default J1 value is ALU 7705 SAR. The value does not change when the encap-type
changes. The J1 string contains all zeros for a non-provisioned path.
Parameters trace-string — specifies an alphanumeric string value. If the string contains spaces,
enclose it in quotation marks.
Values 1 to 62 bytes for SONET or 1 to 15 bytes for SDH
To Next Page
Loading...
