Nokia 7705 SAR - Page 478

7705 SAR Interfaces
478
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Default no encap-type
Parameters atm — specifies the encapsulation type as ATM for ATM pseudowires
cem — specifies the encapsulation type as circuit emulation mode (CEM) for TDM
pseudowires
frame-relay — specifies the encapsulation type as frame relay
cisco-hdlc — specifies the encapsulation type as Cisco HDLC
hdlc — specifies the encapsulation type as HDLC
ipcp — specifies the encapsulation type as IPCP for a PPP/MLPPP channel group in
access mode on the 2-port OC3/STM1 Channelized Adapter card, 16-port T1/E1
ASAP Adapter card, 32-port T1/E1 ASAP Adapter card, or 4-port T1/E1 and RS-232
Combination module. IPCP is not supported on fractional T1/E1 channels on a 2-port
OC3/STM1 Channelized Adapter card.
ppp-auto — specifies the encapsulation type as PPP for PPP/MLPPP bundles in
network mode.
idle-cycle-flag
Syntax idle-cycle-flag {flags | ones}
no idle-cycle-flag
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command configures the value that the DS0, DS1, DS3, E1, or TDM interface transmits
during idle cycles. This command is applicable only if the encapsulation type is ppp-auto.
The no form of this command changes the idle cycle flag to the default value.
Default flags (0x7E)
Parameters flags — use 0x7E as the idle cycle flag
ones — use 0xFF as the idle cycle flag
idle-payload-fill
Syntax idle-payload-fill {all-ones | pattern pattern}
no idle-payload-fill
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group