Nokia 7705 SAR - Page 514

7705 SAR Interfaces
514
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
t391dte
Syntax t391dte keepalive
no t391dte
Context config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
config>port>serial>v35>channel-group>frame-relay
config>port>serial>x21>channel-group>frame-relay
Description This command configures the DTE keepalive timer for the frame relay LMI.
This number specifies the interval at which the DTE sends out a keepalive response request
to the DCE.
The no form of this command returns the t391dte keepalive timer to the default value.
Default 10
Parameters keepalive — sets the interval, in seconds, between status inquiries issued by the DTE
Values 5 to 30
t392dce
Syntax t392dce keepalive
no t392dce
Context config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>e3>frame-relay
config>port>serial>v35>channel-group>frame-relay
config>port>serial>x21>channel-group>frame-relay
Description This command configures the DCE keepalive timer for the frame relay LMI.
This number specifies the interval at which the DCE checks for keepalive responses from the
DTE.
The no form of this command returns the t392dce keepalive timer to the default value.
Default 15
Parameters keepalive — sets the expected interval, in seconds, between status inquiries issued by
the DTE
Values 5 to 30