7705 SAR Interfaces
236
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Use the following CLI syntax to configure a SONET/SDH access port on a 2-port
OC3/STM1 Channelized Adapter card.
CLI Syntax: port port-id
tdm
ds1 ds1-id
channel-group channel-group
encap-type atm
mode access
[no] shutdown
The following CLI syntax shows an example of configuring a SONET/SDH access
port on a 2-port OC3/STM1 Channelized Adapter card.
Example: config# port 1/2/2
config>port# tdm
config>port>tdm#ds1 22
config>port>tdm>ds1# encap-type atm
config>port>tdm>ds1# mode access
config>port>tdm>ds1# no shutdown
config>port>tdm>ds1# exit
config>port>tdm># exit
config>port# exit
Use the following CLI syntax to configure a SONET/SDH access port on a 4-port
OC3/STM1 / 1-port OC12/STM4 Adapter card.
CLI Syntax: port port-id
tdm
ds1 ds1-id
channel-group channel-group
encap-type cem
mode access
[no] shutdown
The following CLI syntax shows an example of configuring a SONET/SDH access
port on a 4-port OC3/STM1 / 1-port OC12/STM4 Adapter card.
Example: config# port 1/2/3
config>port# tdm
config>port>tdm#ds1 24
config>port>tdm>ds1# encap-type cem
config>port>tdm>ds1# mode access
config>port>tdm>ds1# no shutdown
config>port>tdm>ds1# exit
config>port>tdm># exit
config>port# exit
To Next Page
Loading...
