Nokia 7705 SAR - Page 253

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 253
Next, change the value of the timeslots configuration (currently, all timeslots are
allocated to this channel group):
CLI Syntax: port port-id
tdm
e1
channel-group 1
timeslots 11-20
Use the config port info command to display the new port configuration information:
*A:ALU-A>config>port# info detail
----------------------------------------------
description "DS1/E1"
tdm
e1
shutdown
framing g704
no loopback
clock-source node-timed
no signal-mode
report-alarm ais los
no report-alarm oof rai looped ber-sd ber-sf
no hold-time
ssm
shutdown
ssm-bit 8
no tx-dus
channel-group 1
shutdown
description "DS0GRP"
mode network
encap-type ppp-auto
no mtu
network
queue-policy "default"
exit
timeslots 11-20
crc 16
idle-cycle-flag flags
no scramble
ppp
keepalive 10 dropcount 3
exit
exit
exit
line-impedance 120
exit
no shutdown
----------------------------------------------
*A:ALU-A>config>port#