Nokia 7705 SAR - Page 272

7705 SAR Interfaces
272
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
clock-source node-timed
no signal-mode
report-alarm ais los
no report-alarm oof rai looped ber-sd ber-sf
no hold-time
ssm
shutdown
ssm-bit 8
no tx-dus
channel-group 1
description "DS0GRP"
mode access
encap-type hdlc
no mtu
timeslots 2-32
crc 16
idle-cycle-flag flags
no scramble
no shutdown
exit
no shutdown
exit
line-impedance 120
exit
no shutdown
----------------------------------------------
*A:ALU-A>config>port#
Use the following CLI syntax to configure an X.21 serial port (super-rate speed) on a
12-port Serial Data Interface card for HDLC. The syntax for a V.35 serial port is
similar.
CLI Syntax: port port-id
serial
x21
channel-group channel-group-id
encap-type {cem | ipcp | frame-relay
| hdlc | cisco-hdlc}
mode access
no shutdown
speed
{1200|2400|4800|9600|19200|38400|56000
|64k|128k|256k|384k|512k|640k|768k|89k
|1024k|1152k|1280k|1408k|1536k|1664k
|1792k|1920k}
exit
no shutdown
exit
exit
no shutdown
Use the config port info command to display the new port configuration information: