Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 429
group
Syntax group sonet-sdh-index payload {tu3 | vt2 | vt15}
Context config>port>sonet-sdh
Description This command configures the SONET/SDH group payload on a 2-port OC3/STM1
Channelized Adapter card.
Default n/a
Parameters sonet-sdh-index — specifies the components making a SONET/SDH path as configured
by the path command. Depending on the type of SONET/SDH port, the sonet-sdh-
index must specify more path indexes to indicate the payload location of the path.
tu3 — specifies the tributary unit group (TUG3) on a path and configures the port or
channel for transport network use
vt2 — configures the path as a vt2 type virtual tributary group
vt15 — configures the path as a vt15 type virtual tributary group
hold-time
Syntax hold-time {[up hold-time-up] [down hold-time-down]}
no hold-time
Context config>port>sonet-sdh
Description This command configures SONET link dampening timers in 100s of milliseconds, to guard
against reporting excessive interface transitions. Once implemented, subsequent transitions
of the interface from one state to another are not advertised to upper layer protocols until the
configured timer has expired.
Default no hold-time
Parameters hold-time-up — the hold-timer for link up event dampening. A value of zero (0) indicates
that an up transition is reported immediately.
Values 0 to 100 (in 100 ms)
hold-time-down — the hold-timer for link down event dampening. A value of zero (0)
indicates that a down transition is reported immediately.
Values 0 to 100 (in 100 ms)
To Next Page
Loading...
