7705 SAR Interfaces
486
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
framing (DS3)
Syntax framing {c-bit | m23}
Context config>port>tdm>ds3
Description This command specifies DS3 framing for the associated DS3 port.
Default c-bit
Parameters c-bit — configures the DS3 port for C-bit framing
m23 — configures the DS3 port for M23 framing
framing (E3)
Syntax framing g751
Context config>port>tdm>e3
Description This command specifies E3 framing for the associated E3 port.
Default g751 (this default cannot be changed)
Parameters g751 — configures the E3 port for g751 framing
idle-cycle-flag
Syntax idle-cycle-flag {flags | ones}
no idle-cycle-flag
Context config>port>tdm>ds3
config>port>tdm>e3
Description This command configures the value that the DS3/E3 interface transmits during idle cycles.
This command is applicable only if the encapsulation type is ppp-auto. For ATM ports, the
configuration does not apply and only the no form is accepted.
The no form of this command resets the idle cycle flag to the default value.
Default flags (0x7E)
no idle-cycle-flag (for ATM)
Parameters flags — use 0x7E as the idle cycle flag
ones — use 0xFF as the idle cycle flag
To Next Page
Loading...
