7705 SAR Interfaces
490
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
keepalive
Syntax keepalive time-interval [dropcount drop-count]
no keepalive
Context config>port>tdm>ds3>ppp
config>port>tdm>e3>ppp
Description This command sets the interval between keepalive messages.
The no form of this command returns the interval to the default value.
Default keepalive 10 dropcount 3
Parameters time-interval — the time in seconds between keepalive messages, expressed as a
decimal integer
Values 1 to 60
drop-count — the number of consecutive keepalive failed request attempts or remote
replies that can be missed before the port becomes operationally down
Values 1 to 255
report-alarm
Syntax [no] report-alarm {ais | los | oof | rai | looped}
Context config>port>tdm>ds3
config>port>tdm>e3
Description This command enables logging of DS3 and E3 alarms for a DS3/E3 port or channel. When
configured, logging is enabled for the raising and clearing of the specified alarms.
The no form of this command disables logging of the specified alarms.
Parameters ais — reports alarm indication signal errors
Default ais alarms are issued
los — reports loss of signal errors
Default los alarms are issued
oof — reports out-of-frame errors
Default oof alarms are not issued
rai — reports remote alarm indication signal errors
Default rai alarms are not issued
looped — reports looped packets errors
Default looped alarms are not issued
To Next Page
Loading...
