7705 SAR Interfaces
500
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
mode
Syntax mode access
Context config>port>voice>em>channel-group
config>port>voice>fxo>channel-group
config>port>voice>fxs>channel-group
Description This command configures a channelized voice interface for access mode operation. Network
mode is not supported.
An access port or channel is used for customer-facing traffic on which services are
configured. A Service Access Point (SAP) can only be configured on an access port or
channel.
When a port or channel is configured for access mode, the encap-type must be specified (in
this case, cem) to distinguish the services on the port.
Default access
Parameters access — specifies the channelized E&M, FXO, or FXS voice port as service access
To Next Page
Loading...
