Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 539
For the 7705 SAR-X:
*A:ALU-1># show card state
===============================================================================
Card State
===============================================================================
Slot/ Provisioned Type Admin Operational Num Num Comments
Id Equipped Type (if different) State State Ports MDA
-------------------------------------------------------------------------------
1 iom-sar up up 3
1/1 i8-chds1-x up up 8
1/2 i7-mix-eth up up 7
1/3 i7-mix-eth up up 7
A csm-2.5g up up Active
===============================================================================
*A:ALU-1>#
Table 33 Show Card State Output Fields
Label Description
Slot/Id The slot number of the card in the chassis
Provisioned Type The card type that is configured for the slot
Equipped Type (if different) The card type that is actually populated in the slot if
different from the provisioned type
Admin State up: the card is administratively up
down: the card is administratively down
Operational State up: the card is operationally up
down: the card is operationally down
provisioned: there is no card in the slot but it has been
preconfigured
failed: the installed card has operationally failed
Num Ports The number of ports available on the provisioned card
Num MDA The number of adapter cards installed
Comments Indicates which CSM is the active card and which is in
standby mode (for redundancy)
To Next Page
Loading...
