Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 629
Ethernet-like Medium Statistics
Alignment Errors The total number of packets received that had a length
(excluding framing bits, but including FCS octets) of
between 64 and 1518 octets, inclusive, but that had either
a bad Frame Check Sequence (FCS) with an integral
number of octets (FCS Error) or a bad FCS with a non-
integral number of octets
FCS Errors The number of frames received that are an integral number
of octets in length but do not pass the FCS check
SQE Errors The number of times that the SQE TEST ERROR is
received
CSE The number of times that the carrier sense condition was
lost or never asserted when attempting to transmit a frame
Too long Frames The number of frames received that exceed the maximum
permitted frame size
Symbol Errors For an interface operating at 100 Mb/s, the number of times
there was an invalid data symbol when a valid carrier was
present
In Pause Frames The number of IEEE 802.3x pause frames received for flow
control; traffic is momentarily disrupted
Sngl Collisions The number of frames that are involved in a single collision,
and are subsequently transmitted successfully
Mult Collisions The number of frames that are involved in more than one
collision and are subsequently transmitted successfully
Late Collisions The number of times that a collision is detected later than
one slotTime into the transmission of a packet
Excess Collisns The number of frames for which a transmission fails due to
excessive collisions
Int MAC Tx Errs The number of frames for which a transmission fails due to
an internal MAC sublayer transmit error
Int MAC Rx Errs The number of frames for which a reception fails due to an
internal MAC sublayer receive error
Out Pause Frames The number of IEEE 802.3x pause frames sent for flow
control; traffic is momentarily disrupted
Table 58 Show Specific Port Output Fields (GigE Port with Optical SFP)
Label Description
To Next Page
