Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 643
Clock Source node: the link uses the internal clock when transmitting
data
loop: the link recovers the clock from the received data
stream
Framing sonet: the port is configured for SONET framing
sdh: the port is configured for SDH framing
Last State Change The last time that the operational status of the port
changed state
Port IfIndex The interface’s index number, which reflects its
initialization sequence
Last Cleared Time The time since the last clear
DDM Events Enabled: digital diagnostic monitoring events is enabled
for the port
Disabled: digital diagnostic monitoring events is disabled
for the port
J0 String The section trace value that is sent to the far-end port
Section Trace Mode byte: the section trace in the SONET section header is
set in bytes
string: a text string is used to identify the SONET section
header
increment-z0: an incremental STM ID is configured
instead of a static value
Rx S1 Byte The synchronization status message value of the
received SONET/SDH S1 byte
Rx K1/K2 Byte The value of the received SONET/SDH K1/K2 byte
Tx S1 Byte The synchronization status message value of the
transmitted SONET/SDH S1 byte
Tx DUS/DNU Indicates whether the transmission of the QL-DUS/DNU
value in synchronization status messages is enabled or
disabled on the port
Rx J0 String (Hex) The hex value of the received J0
Cfg Alarm The type of alarms to be logged and reported for the
SONET/SDH port
Alarm Status The current alarm state
Table 61 Show Specific Port Output Fields (SONET/SDH Port) (Continued)
Label Description
To Next Page
Loading...
