7705 SAR Interfaces
678
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Encap Type null: ingress frames will not use any tags or labels to delineate
a service
dot1q: ingress frames carry 802.1Q tags, where each tag
signifies a different service
Dot1Q Ethertype The protocol carried in a dot1q Ethernet frame
Ing. Pool % Rate The amount of ingress buffer space, expressed as a
percentage of the available buffer space, that will be allocated
to the port for ingress buffering
Egr. Pool % Rate The amount of egress buffer space, expressed as a percentage
of the available buffer space, that will be allocated to the port for
egress buffering
Net Egr. Queue Pol The number of the associated network egress queue QoS
policy, or default if the default policy is used
Egress Rate The maximum amount of egress bandwidth (in kilobits per
second) that this interface can generate
Down-when-looped Enabled: The down-when-looped feature is enabled on the port
Disabled: The down-when-looped feature is disabled on the
port
Keep-alive The time interval between keepalive PDUs transmitted toward
the network during loop detection by the down-when-looped
feature
Loop Detected Indicates whether a loop is detected on the port
Retry The minimum wait time before the port is re-enabled after it is
brought down due to a loop detection
Use Broadcast Addr Indicates whether the down-when-looped feature has been
configured to compare the destination MAC address of
received PDUs to the broadcast MAC address instead of the
MAC address of the port
Loopback The type of loopback configured on the port, either internal or
none
Loopback Time Left The number of seconds left in a timed loopback; if there is no
loopback configured or the configured loopback is latched, the
value is unspecified
Cfm Loopback Indicates whether the CFM loopback is enabled
Table 69 Show Port Detail Output Fields (DSL) (Continued)
Label Description
To Next Page
Loading...
