Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 685
Encap Type null: ingress frames will not use any tags or labels to
delineate a service
dot1q: ingress frames carry 802.1Q tags, where each tag
signifies a different service
Dot1Q Ethertype The protocol carried in a dot1q Ethernet frame
Ing. Pool % Rate The amount of ingress buffer space, expressed as a
percentage of the available buffer space, that will be
allocated to the port for ingress buffering
Net. Egr. Queue Pol The number of the associated network egress queue
QoS policy, or default if the default policy is used
Net Scheduler Mode The mode for servicing CoS queues; 16-priority
scheduling is the only supported value
Egress Rate The maximum amount of egress bandwidth (in kilobits
per second) that this interface can generate
Down-when-looped Enabled: The down-when-looped feature is enabled on
the port
Disabled: The down-when-looped feature is disabled on
the port
Keep-alive The time interval between keepalive PDUs transmitted
toward the network during loop detection by the
down-when-looped feature
Loop Detected Indicates whether a loop is detected on the port
Retry The minimum wait time before the port is re-enabled
after it is brought down due to a loop detection
Use Broadcast Addr Indicates whether the down-when-looped feature has
been configured to compare the destination MAC
address of received PDUs to the broadcast MAC
address instead of the MAC address of the port
Egr. Pool % Rate The amount of egress buffer space, expressed as a
percentage of the available buffer space, that will be
allocated to the port for egress buffering
Loopback The type of loopback configured on the port, either line,
internal, or none
Table 70 Show Port Detail Output Fields (GPON) (Continued)
Label Description
To Next Page
Loading...
