7705 SAR Interfaces
724
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Device Gender The gender of the device:
dce: the device is performing the role of the data
communications equipment
dte: the device is performing the role of the data terminal
equipment
Duplex The duplex mode:
half: single transmission path (supported only if multidrop
data bridge is enabled in slave mode)
full: two independent transmission paths, one in each
direction
Data Position The HCM data start position; applies to RS-232 and X.21
interfaces only
S-Bit-Signaling Indicates whether S-bit signaling is turned on or off;
applies to RS-232 and X.21 interfaces only
Last State Change The last time the operational status of the port changed
state
Channel IfIndex The channel group index number
Loopback The loopback mode for the port or channel:
bidir-b: bidirectional loopback B takes place on the
control card (CSM) side of the adapter card, and is closer
to the system
bidir-e: bidirectional loopback E takes place on the data
device side of the adapter card, and is closer to the line
none: there is no loopback done at the associated port or
channel
Hold time up The hold-timer value for link-up event dampening
Hold time down The hold-timer value for link-down event dampening
Cfg Alarm The HCM alarms to be reported for RS-232 or X.21
interfaces:
hcmOof: local HCM out-of-frame errors are raised and
cleared
hcmRai: HCM remote alarm indication events are raised
and cleared
Alarm Status The current alarm status
Serial Control Leads (The input and output leads, which carry control signals)
Table 74 Show Port Serial Channel Output Fields (Continued)
Label Description
To Next Page
Loading...
