7705 SAR Interfaces
734
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Voice Call Usage Statistics
The state of the channel (non-forwarding, out-of-service,
idle, incoming, or outgoing), and voice call usage
statistics
Note: Non-forwarding means that the channel is in
shutdown mode or has no SAP configured; incoming
means that the call was received by the channel;
outgoing means that the call was originated by the
channel
• Accumulated: the total accumulated statistics since
the last time the statistics were cleared
• I/C Call Count: the number of incoming calls
• I/C Call Count, Ans: the number of incoming calls
that were answered
• I/C Call Time: the total duration (in seconds) of all
incoming calls
• I/C Call Time: the total duration (in seconds) of all
incoming calls that were answered
• 1O/G Call Count: the number of outgoing calls
• O/G Call Count: the number of outgoing calls that
were answered
• O/G Call Time: the total duration (in seconds) of all
outgoing calls
• O/G Call Time: the total duration (in seconds) of all
outgoing calls that were answered
• Out-Of-Service Time: the time (in seconds) for
which the circuit had alarms raised against the
service
• Idle Time: the total duration the circuit was in an idle
state (that is, on-hook)
• Total Call Count: the sum of I/C Call Count and O/G
Call Count
• Total Call Time: the sum of I/C Call Time and O/G
Call Time
Note: The only valid statistics for transmission-only mode
are Idle Time and Out Of Service Time. When the system
is in transmission-only mode and in a forwarding state,
there is no signaling. To show that the system is active
(that is, not in an out-of-service state) the “Idle Time”
counter is incremented. This is a design intent.
Table 75 Show Port Voice Channel Output Fields (Continued)
Label Description
To Next Page
Loading...
