7705 SAR Interfaces
764
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Table 86 Show Port Frame Relay Output Fields
Label Description
Frame Relay Info for port identifier
Mode The frame relay mode:
• dce—specifies the DCE mode
• dte—specifies the DTE mode
• bidir—the bidirectional mode for LMI types ANSI
and ITU
LMI Type The LMI type:
• ansi—specifies ANSI T1.617 Annex D
• itu—specifies ITU-T Q933 Annex A
• none—frame relay LMI is disabled on the port/
channel
• rev1—specifies Rev 1 version of ANSI T1.617
Annex D
FR Interface Status The status of the frame relay interface as determined by
the performance of the DLCMI. If no DLCMI is running,
the frame relay interface will stay in the running state
indefinitely.
N391 DTE The DTE full status polling interval for the frame relay
LMI. The number specifies the frequency at which
inquiries expect a full status report.
N392 DCE The DCE error threshold for the frame relay LMI. The
threshold specifies the number of errors needed to bring
down a link.
N392 DTE The DTE error threshold for the frame relay LMI. The
threshold specifies the number of errors needed to bring
down a link.
N393 DCE The DCE monitored event count for the frame relay LMI
N393 DTE The DTE monitored event count for the frame relay LMI
T392 DCE The DCE keepalive timer for the frame relay LMI.
The number specifies the interval at which the DCE
checks for keepalive responses from the DTE.
T391 DTE The DTE keepalive timer for the frame relay LMI.
The number specifies the interval at which the DTE
sends a keepalive response request to the DCE.
FRF-12 Not supported
To Next Page
Loading...
