Nokia 7705 SAR - Page 805

Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 805
Output Example
*A:ALU-1># show lag description
===============================================================================
Lag Port States
LACP Status: e - Enabled, d - Disabled
===============================================================================
Lag-id Port-id Adm Act/Stdby Opr Description
-------------------------------------------------------------------------------
1(e) up down N/A
1/1/7 up standby down 10/100/Gig Ethernet SFP
1/6/1 up active down 10/100/Gig Ethernet SFP
2(e) up down N/A
1/6/3 up active down 10/100/Gig Ethernet SFP
1/7/3 up standby down 10/100/Gig Ethernet SFP
===============================================================================
*A:ALU-1>#
Encap Val The dot1q or qinq values of the port for the IP interface
Table 105 Show LAG Description Output Fields
Label Description
Lag Port States
LACP Status Indicates whether LACP is enabled or disabled
Lag-id The LAG identifier and LACP status code
Port-id The member physical port ID
Adm Indicates the administrative state of the member port: up
or down
Act/Stdby Indicates whether the port is in active or standby mode
Opr Indicates the operational state of the member port: up or
down
Description The description strings configured for the LAG and
member ports
Table 104 Show LAG Associations Output Fields (Continued)
Label Description