7705 SAR Interfaces
840
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
port
Syntax port port-id atm [interval seconds] [repeat repeat] [absolute | rate]
Context monitor
Description This command enables ATM port traffic monitoring.
Parameters port-id — specifies the physical port ID
seconds — configures the interval for each display in seconds
Values 3 to 60
Default 10
repeat — configures how many times the command is repeated
Values 1 to 999
Default 10
absolute — when the absolute keyword is specified, the raw statistics are displayed
without processing. No calculations are performed on the delta or rate statistics.
rate — when the rate keyword is specified, the rate per second for each statistic is
displayed instead of the delta
Output The following output is an example of ATM port monitoring information.
Output Example
*A:ALU-1# monitor port 1/1/1.1 atm interval 3 repeat 3 absolute
===============================================================================
Monitor ATM statistics for Port 1/1/1.1
===============================================================================
Input Output
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
Octets 330260861 330260861
Cells 6231337 6231337
Unknown VPI/VCI Cells 0
-------------------------------------------------------------------------------
At time t = 3 sec (Mode: Absolute)
-------------------------------------------------------------------------------
Octets 330262504 330262504
Cells 6231368 6231368
Syntax port-id slot[/mda[/port]] or slot/mda/port[.channel]
bundle-id: bundle-type-slot/mda.bundle-num
bundle keyword
bundle-num: 1 to 32
type ima, ppp
To Next Page
Loading...
