Service
interval
500 h
Reset
Fig. 4‐67
V16
Service interval
Reset
Fig. 4‐68
V16
Operation
4‐56
P/N 213828_11
2014 Nordson Corporation
VersaBlue_PPA
Service Interval Setup
When the Service interval time defined by the customer has expired, the
service symbol (open-end wrench) lights up on the starting screen. The
symbol can be used e.g. to signal that the filter needs to be changed.
Reset
The time for the service interval is reset, and the service symbol
is switched off.
500 h (total hours with heaters on)
Software Version 6.47.035 and Higher
Service Interval Setup
The maintenance interval can be switched on and off with the wrench
symbol. When it is switched on, a warning is indicated when the time defined
by the customer as the Maintenance interval has elapsed.
The maintenance interval can be switched on and off at any time. When
switched off, the set time with heater on is stopped; it resumes again when
switched on.
Reset
The timer for the service interval is reset, the warning is revoked,
and the service symbol is switched off.
Switched off or 500 h (total hours with heaters on) when switched on
To Next Page
Loading...
