Nordson VersaBlue VA - Page 5

Table of Contents III
P/N 213828_11
 2014 Nordson Corporation
VersaBlue_PPA
Installation 3‐1.............................................
Transport 3‐1...............................................
Storage 3‐1.................................................
Unpacking 3‐1..............................................
Lifting (Unpacked Melter) 3‐2...............................
Installation Requirements 3‐2.................................
Required Space 3‐2.......................................
Melters with Transformer 3‐3.............................
Exhausting Material Vapors 3‐3.............................
Screwing on Light Tower (Option) 3‐4..........................
Installation Personnel's Experience 3‐4.........................
Electrical Connections 3‐5....................................
Observe when Using Residual Current Circuit Breakers 3‐5.....
Laying Cable 3‐5..........................................
Labels 3‐5.............................................
Operating Voltage 3‐5.....................................
Power Supply 3‐6.........................................
Mains Filter 3‐6.............................................
Installing Kit (Accessory) 3‐6...............................
Connecting Hose 3‐7........................................
Connecting Electrically 3‐7.................................
Connecting 3‐7...........................................
Second Open-end Wrench 3‐7...........................
Disconnecting 3‐8.........................................
Relieving Adhesive Pressure 3‐8..........................
Installing Applicator 3‐9......................................
Conditioning Compressed Air for Applicator Control Modules 3‐9
Connecting Filling Valve (Option) 3‐9...........................
Key-to-line: Selecting Line Speed Voltage or
Line Speed Current on I/O Board 3‐10...........................
Interface Assignment 3‐11.....................................
Interface Standard I/O 3‐11..................................
General Notes 3‐11......................................
Interface Key-to-line 3‐13...................................
One Line Speed Signal Input for all Motors (XS5) 3‐13........
Separate Line Speed Signal Inputs (XS5.1, XS5.2) 3‐13.......
Interface Level Control 3‐14.................................
Pneumatic Connections 3‐15...................................
Pneumatic Pressure Control / Bypass Control 3‐15..............
Required Air Quality 3‐15.................................
Setting Pressures 3‐15...................................
Interface Assignment XS4: Automatic Pneumatic
Pressure Control 3‐16....................................
Interface Assignment XS4: Bypass Control 3‐17.............
Inert Gas 3‐18.............................................
Condensate Disposal when Dry Air is Used as Inert Gas 3‐18.....
Light Tower 3‐19.............................................
Installing Kit (Accessory) 3‐19...............................
Casters 3‐20.................................................
Installing Kit (Accessory) 3‐20...............................
Air Relief Valve (Accessory) 3‐21...............................
Retrofitting Pressure Sensors 3‐21..............................
Retrofitting a Temperature Control Board 3‐21....................
IPC Webserver 3‐21..........................................
Removing Melter 3‐21.........................................
Disposing of Melter 3‐21.......................................