System ready
Fig. 4‐9
Operation
4‐9
P/N 213828_11
2014 Nordson Corporation
VersaBlue_PPA
Key-to-line - settings
Refer to Control Panel - Overview - / M1 to M3.
Select temperature unit,°C (default) or°F
Select pressure unit: bar (default), psi or kPa
Refer to Control Panel - Overview -/ V15.
Set service interval
The service tasks that are to be indicated as well as the intervals must
be stipulated. For recommended intervals refer to section
Maintenance. The intervals may need to be adapted to the operating
conditions.
Refer to Control Panel - Overview - / V16
With software versions 6.47.035 and higher, the maintenance
interval can be switched on and off; if it is to be activated, it must be
switched on upon initial startup.
Additional parameters, depending on model of melter, e.g. inert gas
equipment.
5. Set the seven-day clock.
Refer to Control Panel - Overview - / V8.
6. Assign passwords and select security level, if desired.
Refer to Appendix A, Password and Control Panel - Overview - / V18, V19.
7. Wait until the system is ready for operation (Fig. 4‐9).
8. Pumps with gland: Retighten the gland on pump(s).
Refer to section Maintenance.
Continued ...
To Next Page
Loading...
