Using TCP/IP diagnostic tools 39
tracert [-d] [-h maximum_hops] [-j host_list] [-w
timeout] [target_name]
Example: tracert 200.286.0.32
3
Press Enter.
Result: The system runs the tracert utility.
4
Type Exit to exit the Command Prompt window and return to
Windows.
—End—
The arp command
The arp command displays and modifies the IP-to-physical address
translation tables used by Address Resolution Protocol (arp).
Arp command syntax
The arp command uses the following syntax:
arp -s inet_addr eth_addr [if_addr]
arp -d inet_addr [if_addr]
arp -a [inet_addr] [-N if_addr]
Arp parameters
Parameter Description
-a
Displays current arp entries by interrogating the current
protocol data. If inet_addr is specified, the IP and
physical addresses for only the specified computer
appear. If more than one network interface uses arp,
entries for each arp table appear.
-g
Same as -a.
inet_addr Specifies an Internet address.
if_addr Specifies the Internet address of the interface whose
address translation table should be modified. If not
present, the first applicable interface is used.
eth_addr Specifies a physical address.
-N if_addr Displays the arp entries for the network interface
specified by if_addr.
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.
To Next Page
Loading...
