2-8 Installing the cabinet
AccessNode 323-3001-210 Issue 1.0
Procedure 2-1 (continued)
Unpacking the cabinet
Step Action
5 Carefully remove all crating material from around the cabinet and pallet.
Note:
Do not remove the cabinet from the shipping pallet until the final
placement at the installation site.
6 Open the electronics compartment doors to reach the swing frames.
—continued—
CAUTION
Shipping bracket removal
The top shipping brackets are required to secure the
equipment frames to minimize the effects of external
environmental vibrations.
In Zone 4 regions, the top and bottom shipping brackets are
required.
Always check the shipping brackets, and re-install if
necessary, before leaving the cabinet.
To Next Page
Loading...
Need help?
General
