2-16 Installing the cabinet
AccessNode 323-3001-210 Issue 1.0
Procedure 2-3 (continued)
Preparing the cabinet for installation
Crane operation precautions
Adhere to all local, state, and federal safety standards for crane operations.
Ensure the following guidelines are observed:
• Set up the crane on firm footing.
• Extend the outriggers, block the floaters and insert safety pins.
• Ensure that the crane is “off rubber” during the lift.
• Ensure that the crane is level before lifting to eliminate tipping.
• Do not place any body part underneath the load at any time and do not
stand on the load.
• Use tag lines to maneuver the load.
Eyebolt precautions
Before lifting cabinet, ensure that eyebolts are free of the following visible
defects:
• bent or distorted eye or shank
• obvious wear
• worn and/or distorted threads
• cracks
Cabinet weights
Table 2-6 lists the weight of the S800A cabinets equipped with each of the two
optional roof assemblies.
—continued—
Table 2-6
Cabinet weights
Cabinet (without batteries) Weight
Equipped with air induction roof 2000 lb (907.2 kg)
Equipped with heat exchanger roof 2200 lb (997.9 kg)
To Next Page
Loading...
Need help?
General
