Installing the cabinet 2-7
AccessNode Series 800A Outside Plant Cabinet Installation 323-3001-210 Issue 1.0
Procedure 2-1
Unpacking the cabinet
Use this procedure to unpack the cabinet after the pad is prepared and the
cabinet installation is ready to begin.
Use care when unpacking the cabinet to avoid injury and damage to the
cabinet.
Precautions
The following safety precautions should be observed at all times during the
cabinet installation procedures:
• Do not install equipment until the cabinet is firmly secured to its mounting
pad, as described in this chapter.
• Use special care when working with a cabinet that is not firmly secured to
the mounting pad.
• Do not open the front or rear doors unless the cabinet is firmly secured to
the shipping pallet or the mounting pad.
• Use special care to prevent damage when handling the sealant kit material.
Tools and materials required
• one wrench, 6-8 in. adjustable or open-end 5/8 in. (15.875 mm)
• one claw hammer or ripping bar to remove crating material
• one deep-well socket driver set, 1/2 in. drive
• one sealant kit supplied with the cabinet
Action
Step Action
1 Check the packing notes to verify that all items have been received.
2 Report any discrepancies immediately.
3 Inspect the shipping container for evidence of damage during shipment.
4 Report any such evidence immediately for investigation and possible damage
claims.
—continued—
To Next Page
Loading...
Need help?
General
