Numatics G3 Series - Config Mode Settings

G3 Series EtherNet/IP
TM
DLR Technical Manual
5-34
TDG3EDM1-6EN 3/18
Subject to change without notice
www.asco.com/g3
5.6 Config. Mode
Config Mode Settings
1. Press the SET button to enter the Config Mode sub-menu.
2. Press the SET button to change this parameter to 32, 64,
96 or 128
3. Press the NEXT button to select Yes or No.
a. Selecting No will bring you back to the main
FACTORY DEFAULTS menu.
b. Selecting Yes will cause the node to reset and
return all parameters to the factory default
conditions.
c. Selecting RETURN will bring you back to the main
FACTORY DEFAULS menu
Press the SET button to confirm your choice.
CONFIG MODE
32
CONFIG MODE
64
ACCEPT
INT Y N