Numatics G3 Series - 500 Series Extended Coil Capability; Extended Coil Configuration

G3 Series EtherNet/IP
TM
DLR Technical Manual
9-83
TDG3EDM1-6EN 3/18
Subject to change without notice
www.asco.com/g3
9.5 500 Series Extended Coil Capability
Module firmware revision levels can be confirmed in the integrated graphic display and the built-in web browser. See pg.
46 for more information.
9.6 Extended Coil Configuration
The Extended Coil manifolds must be connected to a G3 Electronics Node to operate. Not all G3
supported protocols will support the Extended Coil Manifolds. Below is a list of the hardware and
minimum firmware levels that support the Extended Coil Manifolds.
Extended Solenoid Coil Capability requirements:
Module
Part Number
Firmware
Communication Module
240-325
Rev 1.01 Build 42509
Valve Driver Module
P599AE508827001
Rev 4.019
The Extended Coil Manifold can be configured to control 3 additional extended coil valve driver
assemblies; unless already configured from the factory. Modify the configuration with either the graphic
display interface as shown on page 34 or using the integrated web server configuation page shown on
page 83.
Valve Series
Number of Extended
Coil Valve Drivers
Total number of coils
Configuration
Selection
Allocated number of I/O
Bytes designated for
valves
501
0
3-32
32 coils
4
1
33-64
64 coils
8
2
65-96
96 coils
12
3
97-128
128 coils
16
502/503
0
1-32
32 coils
4
1
33-48
64 coils
8
2
49-64
64 coils
8
3
65-80
96 coils
12