11.2 Sub-Bus Hub Module
The G3 HUB module allows for branch distribution from the I/O side of the G3 System and can be integrated into the existing
G3 Series Sub-Bus configuration. Auto Addressing allows for trouble free set up and configuration. Input, Output, as well as
Valve manifolds can be attached to the available four Branches on a HUB module. Each G3 System can support up to two HUB
modules, allowing for maximum flexibility. The HUB module is transparent to the I/O side of the G3 and does not reserve one
of the potential sixteen positions.
To Next Page
Loading...
