7.2.4 Replacing the developer
A29246-X20-X-4-7680 / fa701.fm 243
17. On the operator panel, select whether the new developer is to be filled now:
• To fill the developer directly afterward, click the following button:
The printing system remains in "Stop" status..
In this case, continue with step 7. >>> page 245.
• To fill the developer later, click the following button:
All printing system assemblies are checked (duration approx. 2-3 minutes) before
the printing system is switched to the "Ready" status.
18. Swivel on the fan to the developer
station and turn the turning knob to the
right.
19. Close the left and center door at the back of the printing system.
20. Click the following button on the operator panel to complete developer replacement:
All printing system assemblies are checked (duration approx. 2-3 minutes) before
the printing system is switched to the "Ready" status.
In both cases, the message on the operator panel is automatically deleted, the
replacement of the developer is recorded in the <Consumables history> menu and
the consumable counter is reset.
Proceed as follows:
5 of 5
To Next Page
