7.3.6 Replacing the cleaning belt
A29246-X20-X-4-7680 / fa703.fm 299
Install cleaning belt
Proceed as follows:
Note
Holding pins, bearings and rolls are shaped so that there is only one way to fit them.
The upper roll (new, full roll) is longer than the lower roll.
1. Place the new full roll on the spring
bearing at top right, press to the right
and slide onto the left bearing with the
holding pins.
Turn the new full roll so that it engages
with the holding pins.
2. Insert the new empty roll into the lower
bearings.
1 of 3
To Next Page
Loading...
