Oki C911 - Page 189

45530603TH Rev.2
5-48
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
Table 5-8-3 Panel display when paper sensor sensitivity adjustment (WIDTH SNS ADJ
EXE) ends
Upper line of the
display
Lower line of the display
Details
Details
OK / ERROR NAME WIDTH SNS ADJ RSLT Upper line:
“OK” is displayed for the normal end.
When an error occurs, an error name is
displayed. (Refer to the Table 5-8-4)
Lower line:
“WIDTH SNS ADJ RSLT” is displayed
(Refer to the Table 5-8-5)
Table 5-8-4 Errors of paper width sensitivity adjustment
Displayed error name Contents
ADJ PAPER WIDTH
ERR
The result of paper width detection for correction media is out of
the specified range.
The paper width of correction media detected by the normal
sensitivity (without adjustment) is not within the specified paper
width, ±16.0mm.
GUIDE MINI WIDTH
ERR
The detection result at the narrowest position of the paper guide is
out of the specified range.
The paper width of the paper guide detected by the normal
sensitivity (without adjustment) is not within the narrowest size,
64.0±16.0mm.
ADJUST VALUE
ERROR
A calculated slant adjustment or offset adjustment value is out of
the specified range.
Slant adjustment : No within ±0.02
Offset adjustment value: Not within ±16.0.
Table 5-8-5 PAPER WIDTH ADJ RSLT
Upper line of
the display
Lower line of
the display
Details Memory
ADJUST
PAPER
WIDTH
AD=***H
W=***.*mm
Paper width detection result of adjustment media
AD: Sensor scanning AD value [Hex] of
adjustment media width
W: Value converted from a sensor reading AD
value as the mm unit.
SRAM
GUIDE
MINIMUM
WIDTH
AD=***H
W=***.*mm
Detection result of the narrowest position
AD: Sensor scanning AD value [Hex] at the
narrowest position
W: Value converted from a sensor reading AD
value as the mm unit.
SRAM
SLANT
ADJUST
VALUE
*.**** Calculated slant adjustment value.When an error
occurs, 0.0000 is displayed.
EEPROM
OFFSET
ADJUST
VALUE
***.* Calculated offset adjustment value.
When an error occurs, 00.0000 is displayed.
EEPROM
• Results will be stored as described in memory filed.
• The contents in SRAM are deleted when the test starts, and values detected at the
normal competition or until the apparatus stops due to errors are written.
• The contents in EEPROM are updated only at the normal competition of the test.