207
Sample Program 1 N000 P008 XY
N001 G11
N002 G63 E00=0
N003 G63 A1000=100
N004 G63 A1001=100
N005 G01 XA1000 YA1001 F20 M10
N006 G01 X0 Y0 F50
N007 G60 A1000=A1000+20
N008 G70 N005/L9
N009 G63 A1000=100
N010 G60 A1001=A1001+30
N011 G60 E00=E00+1
N012 G71 N005/E0 ! 5
N013 G79
Explanation Block N000 declares the program number and axes being used.
N001
Specifies Stop mode.
N002
Initializes register E0 to 0.
N003
Substitutes the X-axis’ initial position data into address A1000.
N004
Substitutes the Y-axis’ initial position data into address A1001.
N005
Moves the axes by linear interpolation to the X position indicated in A1000 and
the Y position indicated in A1001.
N006
Returns to the origin.
N007
Increments the X-axis’ position data by 20.
N008
Jumps to block N004 and repeats the above process 9 times.
N009
Initializes the X-axis’ position data to its original value.
N010
Increments the Y-axis’ position data by 30.
N011
Uses register E0 as a loop counter with an initial value of 0. The content of E0 is
incremented by 1.
N012
Jumps to N004 as long as the content of E0 isn’t 5. When E0=5, N012 proceeds
to the next block and ends the program.
N013
Ends the program.
Calculating Position Data
Section 9-7
To Next Page
Loading...
Need help?
General
