72
Name OperandsCode
SUBPROGRAM END G73 ---
OPTIONAL END G74
j<Optional number>
OPTIONAL SKIP G75
j<Optional number>
OPTIONAL PROGRAM STOP G76
j<Optional number>
PROGRAM END G79 ---
ABSOLUTE SPECIFICATION G90 ---
INCREMENTAL SPECIFICATION G91 ---
Note Operand punctuation:
a) < > Content to be input.
b) [ ] Option
c) ... Multiple specification is possible.
d)
j The space is required.
e) _ The space can be left out.
5-3 List of G Symbols
The following table lists the symbols used in G-language programming.
Symbol Meaning
A Indicates a position data address. There are 2000 addresses ranging
from A0000 to A1999.
E Indicates an indirect register. There are 32 indirect registers ranging from
E00 to E31.
F Indicates the speed when performing interpolation operations.
G G function
I Arc center coordinate for the X-axis.
J Arc center coordinate for the Y-axis.
L Number of loops
M M code
N Block number
P Program number
R Circle radius
X X-axis
Y Y-axis
/ Punctuation mark
( ) Indirect specification
# Optional number, parameter type
* Comment
List of G Symbols
Section 5-3
To Next Page
Loading...
