91
Variable Area Map Section 5-10
7 6 5 4 3 2 1 0 Bit position
0000
Status
Value of bit
01
Current exceeded
Not detected Detected
15 14 13 12 11 10 9 8
00
Current hold
Refresh Hold
Indicate range
exceeded.
Not detected Detected
Input error
Not detected Detected
Heating output
(See note.)
OFF ON
Cooling output
(See note.)
OFF ON
HB output
OFF
ON
Alarm output 1
OFF
ON
Alarm output 2
OFF
ON
Alarm output 3
OFF
ON
23 22 21 20 19 18 17 16 Bit position
000
Status
Value of bit
01
Event input OFF ON
31 30 29 28 27 26 25 24
00
Write mode Backup RAM write
EEPROM
(See note.)
RAM = EEPROM RAM
≠ EEPROM
Setting area Setting area 0 Setting area 1
AT execute/cancel
AT canceled AT executing
RUN/STOP RUN STOP
Data writing Disable Enable
Auto/manual Automatic Manual
Note: EEPROM is the internal non-volatile memory.
000
Note: For pulse output models, the status of these bits
shows the status of the corresponding operation
indicators. For analog output modes, the status
of these bits is undefined (i.e., the bits will not
necessarily show the status of the indicators).
To Next Page
Loading...
